p11 1968

rockin · Post by **rockin** » Wed May 09, 2012 5:41 pm

Hi All,

New to the forum and i'm currently restoring a 1968 P11. I'm looking for info on the spacer between the crankcase and inner chaincase! does anyone know the width of the spacer or anywher this info is available?

thanks in advance

Rockin

g80csp11 · Post by **g80csp11** » Wed May 09, 2012 6:46 pm

ANTHONY CURZON will be able to tell you the part number , thickness , the name of teh guy on made them in the factory. just waait a few days for his reply
honestly , he has studied teh P11's in some depth

John Donne · Post by **John Donne** » Wed May 09, 2012 8:26 pm

Do you mean the one that has three holes in it and fits between the front of the chaincase and the drive side crankcase? The part number 030243 and it is shown in all the parts books. It is also used on all the G15, N15, and 33 series of bikes. Try Russell Motors or Walridge Motors in Canada. There are four spacers that are associated with the P11 series primary chaincases as there are three to four types. Two at the back, one inside, and one out side where the footrest is on the long stud through the chaincase. The later modification also added and oil seal from 128646 engine and frame numbers. At the back of the through stud behind the chaincase, it is not a spacer it is a washer part number 000010.

rockin · Post by **rockin** » Mon May 28, 2012 5:31 pm

rockin · Post by **rockin** » Mon May 28, 2012 5:36 pm

anthony curzon can you please contact me my e mail is rtrandallltd@hotmail.co.uk regaurds rockin.