As the kickstart freed off when the outer cover screws were released, try a thicker gasket. I have built loads without gaskets and had no problem. When I built the last one, mine, it was binding the same as yours. Fitted a thin gasket and it was better, fitted a thicker one as supplied by Norvil and it was perfect.
I did check nothing else was adrift, and that all bushes/bearings were fully home first. So did you use a gasket or just silicone?
If it was the dowels they would need to be missing or totally buggered to spoil things.
Mind you, the O-ring could be twisted/nicked/wrong size as well....
Kickstarter Return
- bjork
- Member
- Posts: 1908
- Joined: Wed Jan 01, 1997 12:00 am
- Location: LEICESTERSHIRE UK
- Location: Leicestershire
Kickstarter Return
Using yesterdays technology to create tomorrows problems today
-
- Posts: 9
- Joined: Mon Apr 09, 2007 12:17 pm
- Location: UK
Kickstarter Return
So many good ideas! Stopped being lazy yesterday and took cover off and applied grease to O ring- kickstarter now returns ferociously! Its raining so road test will have to wait a few days. Thanks everyone.
-
- Posts: 9
- Joined: Mon Apr 09, 2007 12:17 pm
- Location: UK
Kickstarter Return
Road test never started, as soon as I turned the engine over with the inention to start the kickstarter did not return. Next I fitted 3 gaskets and all was fine until I tried to start the engine....... I was careful to observe what happened when I next undid the gearbox outer screws and as soon as I released the last one kickstarter returned. I now suspect that the kickstarter return spring is expending sideways and pushing the bush against the oil ring but then there is no problem if I play with the kickstarter with the clutch in. Any fresh ideas?
-
- Member
- Posts: 2882
- Joined: Mon Jan 01, 1990 12:00 am
- Location: USA USA
Kickstarter Return
Check to see if the correct parts are fitted. The factory revised the design about 1963 or so. They fitted a spring with more turns & a better anchor for the fixed end. The inner & outer covers are machined deeper to allow for the longer spring.
Pity they didn't replace the o-ring with a lip seal at that time.
Cheers, Don.
Pity they didn't replace the o-ring with a lip seal at that time.
Cheers, Don.
-
- Posts: 9
- Joined: Mon Apr 09, 2007 12:17 pm
- Location: UK
Kickstarter Return
Thanks Don, anyone out there know how long the kickstater bush should be?