So the Welseal applied to the gasket took a little more around 1800 psi to burst it and held 200 psi ok.
I set up yesterday the RTV instant gasket by degreasing and applying a thin film to both halves, tightening until I could see a slight seepage then fully tightening after an hour. left overnight and tested this morning.
First I can't get it to fail ( pumping like crazy willing it to fail!! ) saw over 3500 psi and then yanking the grease gun off as quick as I can..
https://youtube.com/shorts/-FkBWLihPtM? ... 548BGYyXEg
after about 15 mins its lost about 100 psi but I think its the ball valve in the grease nipple as that seems to be wet after wiping it, I guessing that it will gradually drop to 200 psi like the rest have?
Les, Ive been looking for paper thin enough as really I would only like to go no more than 2 thou between cases?
Don't think there's any point of using a gasket with the RTV
I'm going to get some o rings 1mm section and ask my friend to assist with cutting the O ring groove to compare