I'm moving along with my K8 'improvements' .
In trying to get the rear chain in alignment with the gearbox i have now had to fit a spacer between the frame and brake plate, that's fair enough.
But whilst i was doing this i found that there is a fair bit of movement in the output bearing of the gearbox. I have the correct bearings in my stock of bits.
The question is how best to remove the staking around the bearing without compromising the fit.
Many Thanks .John
K8 gearbox bearings
-
- Member
- Posts: 16
- Joined: Wed Jan 05, 2022 2:09 pm
- Location: Suffolk UK
K8 gearbox bearings
You do not have the required permissions to view the files attached to this post.