copper head gasket
Posted: Fri Apr 14, 2023 9:45 pm
Hi,
I fitted a copper head gasket last time the cylinder head was off. I got it heated to cherry red and quenched in water as advised to soften the metal and it has worked fine without leaks.
I wondered if anyone might know if I can reuse the gasket, and if so do I need to get it annealed again ? It looks fine and I would replace the viton o rings.
I also wondered if using wellseal might be a good idea or not on the head and or paper base gasket or would it just make it very difficult to get apart if necessary in the future.
Thanks,
John
I fitted a copper head gasket last time the cylinder head was off. I got it heated to cherry red and quenched in water as advised to soften the metal and it has worked fine without leaks.
I wondered if anyone might know if I can reuse the gasket, and if so do I need to get it annealed again ? It looks fine and I would replace the viton o rings.
I also wondered if using wellseal might be a good idea or not on the head and or paper base gasket or would it just make it very difficult to get apart if necessary in the future.
Thanks,
John