Hello again. Before I end up drawing them myself, does anyone know if there are any CAD drawings of engine mounting plates for a mid 50's 500 single?
Cheers, Chris
CAD Drawings Engine Mounting Plates
- spookefoote1956
- Member
- Posts: 1841
- Joined: Mon May 01, 2017 7:32 pm
- Location: Wales Innit
CAD Drawings Engine Mounting Plates
Hail Joe Lucas ............ Prince of Darkness!
All my bikes are original........ to me!
"Creativity is your intelligence having fun" Albert Einstein
All my bikes are original........ to me!
"Creativity is your intelligence having fun" Albert Einstein
-
- Member
- Posts: 3367
- Joined: Wed Oct 12, 2005 10:45 pm
- Location: N YORKS UK
Re: CAD Drawings Engine Mounting Plates
Nope, but I do have some currently off my 1956 G80S although I doubt tracings will have the precision that you require!
If it would do, and can wait a few days, I'd do that for you. I did modify the gearbox top mount but marked the original point before hand in case reinstatement was required.
JohnnyB
If it would do, and can wait a few days, I'd do that for you. I did modify the gearbox top mount but marked the original point before hand in case reinstatement was required.
JohnnyB
- spookefoote1956
- Member
- Posts: 1841
- Joined: Mon May 01, 2017 7:32 pm
- Location: Wales Innit
Re: CAD Drawings Engine Mounting Plates
Interestingly enough Johnny I was going to trace some originals then convert to vector
Hail Joe Lucas ............ Prince of Darkness!
All my bikes are original........ to me!
"Creativity is your intelligence having fun" Albert Einstein
All my bikes are original........ to me!
"Creativity is your intelligence having fun" Albert Einstein
-
- Member
- Posts: 3367
- Joined: Wed Oct 12, 2005 10:45 pm
- Location: N YORKS UK
Re: CAD Drawings Engine Mounting Plates
No assistance required then? I can't open the shutters on the lock up myself at present and was there with my daughter (21) this afternoon.
Lots to do tomorrow before chemotherapy starts on Tuesday so email me through the Forum if you need me to do it.
JohnnyB
Lots to do tomorrow before chemotherapy starts on Tuesday so email me through the Forum if you need me to do it.
JohnnyB
- spookefoote1956
- Member
- Posts: 1841
- Joined: Mon May 01, 2017 7:32 pm
- Location: Wales Innit
Re: CAD Drawings Engine Mounting Plates
Sorry Johnny been busy. I'm ok for tracings thanks. Hope the chemo goes well. Stay well brother.
Hail Joe Lucas ............ Prince of Darkness!
All my bikes are original........ to me!
"Creativity is your intelligence having fun" Albert Einstein
All my bikes are original........ to me!
"Creativity is your intelligence having fun" Albert Einstein