Page 1 of 1
G2 engine
Posted: Sun Nov 28, 2021 5:17 pm
by Kiwiengineer
Hi guys I was wondering if it is possible to put the g5 crank shaft ect into a g2 crankcase?
Re: G2 engine
Posted: Sun Nov 28, 2021 10:16 pm
by SPRIDDLER
IKBA about L/W's and no doubt first hand info will be forthcoming.
In the meantime you could look at the Spares List to see which relevant parts are common to both models. (A very quick look shows that the G2 c/case halves have different part numbers vs the G5, although the bearings seem to be common for both).
LW crankcase.JPG
LW bearings.JPG
Both the G2 and G5 parts are in the same document here:
http://archives.jampot.dk/book/Spares_l ... s_List.pdf
Re: personally no idea but its all good stuff if you can.
Posted: Sun Nov 28, 2021 10:18 pm
by Roger Stephenson
if you can.
Roger
Re: G2 engine
Posted: Mon Nov 29, 2021 12:31 pm
by clanger9
Probably, but you'll also need a G5 con rod, barrel, studs, pushrods, piston & head as well as the primary drive & clutch. Not a lot of G2 left at that point...