Page 1 of 2
Burman BAP gearbox.
Posted: Sun Nov 20, 2016 10:21 pm
by Seldal
Hello. I am restoring a 1951 Ajs18cs with Burman BAP gearbox. Where can I find any parts for that box?I need the fourth gear and some small parts. Can't find anything at amoc or ebay. Will Burman Ba, Cp or b 52 parts fit? Thanks for all help.
Re: Burman BAP gearbox.
Posted: Mon Nov 21, 2016 4:09 pm
by Don Madden
The BAP Buman was used on larger Arials, including the square four. The cases are different but internals the same. Don.
Re: Burman BAP gearbox.
Posted: Mon Nov 21, 2016 5:12 pm
by Seldal
Ok,thanks. So only BA parts will fit if I understand it correct?
Re: Burman BAP gearbox.
Posted: Mon Nov 21, 2016 5:26 pm
by dave16mct
Re: Burman BAP gearbox.
Posted: Mon Nov 21, 2016 9:04 pm
by clive
Don Madden wrote:The BAP Buman was used on larger Arials, including the square four. The cases are different but internals the same. Don.
Not sure the internals are the same, mine has a lager diameter drive shaft and consequently all the gears in that shaft have a different size too. I think this version was used on the square 4. Meant I could not use it for the internals I needed for a cp box.
Draganfly motors have pretty much cornered the market on spares for the Burman boxes.
Re: Burman BAP gearbox.
Posted: Tue Nov 22, 2016 11:21 am
by Samuel
Russell Motors also have parts for CP Burman. For BA I think not.
I managed to source a range of parts for a G80 CP gearbox refurbishment with Les Myers at Russell Motors.
Re: Burman BAP gearbox.
Posted: Sun Nov 27, 2016 10:32 pm
by 577typhoon
I have a part restored G3LCS with BAP gearbox. The same box was fitted to Panthers and Vincent Comets. It seems to me that it is basically a beefed up CP box and no parts are interchangeable.
Re: Burman BAP gearbox.
Posted: Mon Nov 28, 2016 7:57 pm
by raffles
why not contact the vincent owners spares at kettering and talk to them
Tony
Re: Burman BAP gearbox.
Posted: Sun Dec 11, 2016 3:11 pm
by Seldal
Thanks folks. I finally found the parts I need at Draganfly. Expensive but great quality.
Re: Burman BAP gearbox.
Posted: Thu Oct 05, 2017 12:42 pm
by Alpine1965
Hi all
I hope this belated reply might get a response .....it's a case of me too - looking for BAP bits more specifically a mainshaft . I would really like to keep my 51 AJS 18CS as original as possible .
I've attached a pic of what I think is the correct mainshaft and would like someone to confirm if it is the correct mainshaft .
The pic includes measurements ( I must admit not exactly precision - but I think good enough for an ID).
So if any one has any leads or info to help me obtain a good mainshaft and subject to the example in the pic confirmed as correct then would be over the moon.
Many thanks for any info .
Cheers
Andrew