Just reassembling my oil pump and wanted to check if I should Wellseal between the pump body and front and back plates or just rely on the metal to metal joint, it's not clear in the manual.
Thanks
Duncan
Twin Oil Pump - to Wellseal or not Wellseal
- Duncan
- Member
- Posts: 2138
- Joined: Thu Jul 10, 2003 1:00 am
- Location: HAMPSHIRE UK
-
- Posts: 2453
- Joined: Mon Jan 01, 2001 12:00 am
- Location: NORTHAMPTONSHIRE UK
Twin Oil Pump - to Wellseal or not Wellseal
I wellsealed mine but was very careful to use the bare minimum. It has been ok for 1700 miles so far.
Lawrence [}:)]
Lawrence [}:)]
-
- Member
- Posts: 1221
- Joined: Fri Jan 01, 1993 12:00 am
- Location: WEST MIDLANDS UK
Twin Oil Pump - to Wellseal or not Wellseal
I would not reccomend putting anything between the pump body and the front and back plates. One part of refurbishing a pump is to grind these plates to remove the wear created on the face of them by the gears during normal use. This helps to improve pump pressure and reduce leaks that cause wet sumping.The fit of plates to gears is intended to be very close and even Wellseal will create what is in effect is a large gap when you start to consider oil at high pressure.
-
- Posts: 2453
- Joined: Mon Jan 01, 2001 12:00 am
- Location: NORTHAMPTONSHIRE UK
Twin Oil Pump - to Wellseal or not Wellseal
Ah! Wonder if that is why mine wet sumps so well [8)]
Lawrence [}:)]
Lawrence [}:)]