Steve, to keep things simple when I fitted my centre stand, I made a one piece bush out of a piece of 1/2" water pipe (just skimmed the O.D. a tad in the lathe to fit the leg eyes) I trimmed the length to JUST slip in between the frame rails. To take the place of the support shoulders of the original two bush's, I trimmed a piece of light gauge tube to firm fit in between the fork leg eyes the I.D. of which was just a little bigger than the one piece bush O.D.
Just fit bush and spacer in stand then hold assembly up in place while the stand through bolt is pushed in place...K.I.S.S.
Paul
(just as well I arn't a rivet counter)
Removal of centre stand assy.
-
paul knapp
- Posts: 1645
- Joined: Wed Oct 12, 2005 10:45 pm
- Location: SOUTH AUSTRALIA AUSTRALIA
Removal of centre stand assy.
___“As a hobby for the technically minded, motorcycling provides great scope.”
J.B.Nicholson
Don't worry about the world coming to an end today. It's already tomorrow in Australia!
_____________________________________________
J.B.Nicholson
Don't worry about the world coming to an end today. It's already tomorrow in Australia!
_____________________________________________