lightweight wiring harness

Information relating to the Matchless G5 or AJS Model 8 350cc Lightweight
Post Reply
g80csp11
Member
Posts: 1759
Joined: Mon Jan 01, 1990 12:00 am
Location: WEST SUSSEX UK

lightweight wiring harness

Post by g80csp11 »

Ive made a new wiring harness that needs testing (product development for spares scheme), and im looking for someone that is willing to fit it to their lightweight while the fuel tank is off to check , loom lengths , earth points and function with the Alternator connected. It is new with new Wipac connectors

It needs a electronic rectifier/regulator rather than rely on the resistance wire as this will give better control of voltage
It will work with both 6 or 12V set up ( ie AO services unit)

Is there anyone in the Mid Sussex area willing to assist ?
contact Peter Gibson 07801334736
TERRY R
Member
Posts: 3
Joined: Tue May 29, 2018 8:23 pm
Location: Staffordshire UK

Re: lightweight wiring harness

Post by TERRY R »

I AM NOT IN SUSSEX BUT I AM FINISHING A TOTAL RESTORATION ON MY G5,AND CANNOT FIND A HARNESS FOR IT.IF YOU DO GO INTO MAN8UFACTURE OF THESE HARNESSES BUT IT MUST BE CLOSE TO THE ORIGINAL ITEM I FOR ONE WOULD LIKE TO PURCHASE UP TO FOUR.PLEASE ADVISE.THANKYOU.Terry
g80csp11
Member
Posts: 1759
Joined: Mon Jan 01, 1990 12:00 am
Location: WEST SUSSEX UK

Re: lightweight wiring harness

Post by g80csp11 »

Thanks Terry for reply , I'll give you a ring during week
Im club membership secretary , so have your details if thats OK

The only difference is that the wiring colors are different , but I have a wiring diagram
It needs to be used with a electronic rectifier / regulator ( 6 or 12V) as it does not have the resistance wire fitted . this was a weak point on the original Wipac harness used by AMC dumping power when the lights were off
Post Reply