Hi All
When refitting the side stand I also fitted a new spring but am struggling to find the right place on the frame to locate the spring end.
The previous owner had it hocked onto a cable tie around the frame, which is where it is at present, but this means that it does no spring back with much vigour.
Regards
Gary
Side Stand Spring fitting
- AFPU
- Member
- Posts: 55
- Joined: Sun Oct 03, 2021 7:09 pm
- Location: New South Wales AUSTRALIA
- Location: Kenninghall
Side Stand Spring fitting
Gary
"Any fool can make things complicated but it takes a genius to make things simple"
"Any fool can make things complicated but it takes a genius to make things simple"
- Duncan
- Member
- Posts: 2145
- Joined: Thu Jul 10, 2003 1:00 am
- Location: HAMPSHIRE UK
Re: Side Stand Spring fitting
Hi Gary, if you look at this ( https://www.jampot.com/pic_display.asp?id=493 ) photo on the main site you will see where they are located if you want the stand to retract on its own, if you wish it to stay down until pushed back the you need to improvise a fitting near the front of the frame.
- AFPU
- Member
- Posts: 55
- Joined: Sun Oct 03, 2021 7:09 pm
- Location: New South Wales AUSTRALIA
- Location: Kenninghall
Re: Side Stand Spring fitting
Excellent. As they say a picture paints a thousand words!
Gary
"Any fool can make things complicated but it takes a genius to make things simple"
"Any fool can make things complicated but it takes a genius to make things simple"