CAD Drawings Engine Mounting Plates

[spookefoote1956]

Hello again. Before I end up drawing them myself, does anyone know if there are any CAD drawings of engine mounting plates for a mid 50's 500 single?

Cheers, Chris

[56G80S]

Nope, but I do have some currently off my 1956 G80S although I doubt tracings will have the precision that you require!

If it would do, and can wait a few days, I'd do that for you. I did modify the gearbox top mount but marked the original point before hand in case reinstatement was required.

JohnnyB

[spookefoote1956]

Interestingly enough Johnny I was going to trace some originals then convert to vector

[56G80S]

No assistance required then? I can't open the shutters on the lock up myself at present and was there with my daughter (21) this afternoon.

Lots to do tomorrow before chemotherapy starts on Tuesday so email me through the Forum if you need me to do it.

JohnnyB

[spookefoote1956]

Sorry Johnny been busy. I'm ok for tracings thanks. Hope the chemo goes well. Stay well brother.