My toolbox needs saving!
-
- Posts: 208
- Joined: Sat Sep 07, 2019 5:51 pm
- Location: Hampshire UK
-
- Member
- Posts: 3406
- Joined: Wed Oct 12, 2005 10:45 pm
- Location: N YORKS UK
Re: My toolbox needs saving!
Well done Mark and also for providing the outcome, not everyone does.
Johnny B
Johnny B
-
- Member
- Posts: 1439
- Joined: Sat Oct 09, 2010 9:17 pm
- Location: ABERTAWE UK
Re: My toolbox needs saving!
Yes I couldn't agree more Johnny about knowing the outcome of a post, good repair so well done.
Colin
Colin
only dead fish go with the flow
- Cjay59_LAPSED
- Posts: 520
- Joined: Mon Nov 05, 2012 3:43 pm
- Location: Cork, Ireland
- Contact:
Re: My toolbox needs saving!
Great stuff Mark, like to see it on the bike when done, kicked over mine and took it out for its first run for a while today....
-
- Posts: 208
- Joined: Sat Sep 07, 2019 5:51 pm
- Location: Hampshire UK
-
- Member
- Posts: 452
- Joined: Tue May 27, 2003 1:00 am
- Location: SHROPSHIRE UK
Re: My toolbox needs saving!
I would work some sealant around the hinge repair edges to retard further damage.
-
- Posts: 90
- Joined: Mon Mar 07, 2011 9:41 am
- Location: BUCKS UK
Re: My toolbox needs saving!
You don't have a head steady fitted, although there is a mark on the frame that suggests one was fitted. Mine was also missing - does anyone have experience of with and without the steady fitted? How important is it.
Jeremy
Jeremy
- ajscomboman
- Member
- Posts: 3987
- Joined: Mon Jan 01, 1990 12:00 am
- Location: HAMPSHIRE UK
Re: My toolbox needs saving!
Funnily enough I went through this with Mark the other day explaining the fitting if the head steady and clip, and why it's important NOT to fit the clip either side on the steady plate. If it's not fitted you'll notice the vibes much more.Jdraper wrote:You don't have a head steady fitted, although there is a mark on the frame that suggests one was fitted. Mine was also missing - does anyone have experience of with and without the steady fitted? How important is it.
Jeremy
-
- Posts: 208
- Joined: Sat Sep 07, 2019 5:51 pm
- Location: Hampshire UK
Re: My toolbox needs saving!
It wasn't fitted when I got the bike, you can see in the photo though that the tip clip is there, it's slipped down the frame.Jdraper wrote:You don't have a head steady fitted, although there is a mark on the frame that suggests one was fitted. Mine was also missing - does anyone have experience of with and without the steady fitted? How important is it.
Jeremy
I have to change the bolts on the rocker cover as the ones on there don't have the fitting for the stay. Club shop to the rescue once again!