Swinging Arm Spindle
-
- Member
- Posts: 1439
- Joined: Sat Oct 09, 2010 9:17 pm
- Location: ABERTAWE UK
Re: Swinging Arm Spindle
That sorts that out then, thanks Nev.
Colin
Colin
only dead fish go with the flow
- Martin.S
- Posts: 443
- Joined: Sun Mar 18, 2018 12:02 pm
- Location: Bristol UK
Re: Swinging Arm Spindle
For some reason I couldn't open that picture at work but now I've got 5 minutes at home I can see it - thanks Colin - perfect.
Cheers
Cheers
- Martin.S
- Posts: 443
- Joined: Sun Mar 18, 2018 12:02 pm
- Location: Bristol UK
Re: Swinging Arm Spindle
Can anyone help me with the fitted length?
Cheers
Cheers
- ajscomboman
- Member
- Posts: 3987
- Joined: Mon Jan 01, 1990 12:00 am
- Location: HAMPSHIRE UK
Re: Swinging Arm Spindle
From the inner face of the swing arm to the inner most face of the cotter pin 107.19mm or 4.220"
- Martin.S
- Posts: 443
- Joined: Sun Mar 18, 2018 12:02 pm
- Location: Bristol UK
Re: Swinging Arm Spindle
Would that be the flat face or the chamfer? Thanks Rob.inner most face of the cotter pin
Martin.
- ajscomboman
- Member
- Posts: 3987
- Joined: Mon Jan 01, 1990 12:00 am
- Location: HAMPSHIRE UK
Re: Swinging Arm Spindle
Taken from the inner most edge of the cotter pin slot.Martin.S wrote:Would that be the flat face or the chamfer? Thanks Rob.inner most face of the cotter pin
Martin.
- Martin.S
- Posts: 443
- Joined: Sun Mar 18, 2018 12:02 pm
- Location: Bristol UK
Re: Swinging Arm Spindle
Sorry to be such a pain but I don't want to get this wrong and reading text isn't as clear as talking face to face and I'm not 100% sure if we are talking about the same detail.
In my sketch below there is an angle either side to the slot, if this is correct would your measurement be A or B?
Cheers
Martin
In my sketch below there is an angle either side to the slot, if this is correct would your measurement be A or B?
Cheers
Martin
You do not have the required permissions to view the files attached to this post.
- ajscomboman
- Member
- Posts: 3987
- Joined: Mon Jan 01, 1990 12:00 am
- Location: HAMPSHIRE UK
Re: Swinging Arm Spindle
Err, on my original spindle there is no chamfer its a square edge slot. This bike is a 1 owner bike that's not been apart until now so it's definitely an original pin..
-
- Member
- Posts: 1439
- Joined: Sat Oct 09, 2010 9:17 pm
- Location: ABERTAWE UK
Re: Swinging Arm Spindle
Same as my pin ..................no chamfers.
Colin
Colin
only dead fish go with the flow
- Martin.S
- Posts: 443
- Joined: Sun Mar 18, 2018 12:02 pm
- Location: Bristol UK
Re: Swinging Arm Spindle
My arm had an alien spindle in it so I presumed the spindle had chamfers - that makes it easier to make without them.
Thank you chaps
Martin
Thank you chaps
Martin