Stuck Chronometric Speedo
- thornebt
- Posts: 488
- Joined: Sun Apr 19, 2015 9:13 am
- Location: Somerset, UK
Stuck Chronometric Speedo
Having finally managed to sort the starting problems on my G80S I now have a new problem. The speedo is stuck at 23mph. It had previously been stuck at zero but I put an electric drill on the gearbox end of the cable and turned it anti-clockwise and it settled at 23mph and stuck there. I need to take it out on the road and hope that perhaps something will jog it back to normal operation. Has anyone had this problem please?
Cheers. Bruce.
Cheers. Bruce.
- clive
- Member
- Posts: 5708
- Joined: Mon Jan 01, 1990 12:00 am
- Location: LONDON UK
Re: Stuck Chronometric Speedo
Our Speedos are clockwise drive when looking down on the cable at the Speedo end from above. If you use a drill to drive them it needs to be set in the reversing mode. If you were driving it anticlockwise looking from the gearbox end it ought to read the speed. It may be that if you turn the cable slowly by hand that it will drop back to zero. The smiths Speedo tests the speed about every 6 feet on the road. If you stop the drill dead at the wrong point it may not zero. Then again it may be knackered!
clive
if it ain't broke don't fix
if it ain't broke don't fix
- thornebt
- Posts: 488
- Joined: Sun Apr 19, 2015 9:13 am
- Location: Somerset, UK
Re: Stuck Chronometric Speedo
I did use the drill to drive it anti-clockwise. I've taken the bike out for a run and the needle didn't move from 23mph. I know the speedos are fiendishly expensive! Can anyone recommend a repairer please? Preferably in the Somerset / Bristol area if possible. Cheers. Bruce.
- robcurrie
- Member
- Posts: 956
- Joined: Fri Dec 09, 2011 5:33 pm
- Location: Limpopo SOUTH AFRICA
- Contact:
Re: Stuck Chronometric Speedo
Bruce, did you perhaps oil the speedo cable just before it got stuck? Oil travels up the cable and into the clockwork. If so, you can clean it out with methylated spirits and it should work again.
Rob C
Rob C
- thornebt
- Posts: 488
- Joined: Sun Apr 19, 2015 9:13 am
- Location: Somerset, UK
Re: Stuck Chronometric Speedo
Hi Rob
Yes, I did oil the cable. It was before I read the current thread on here about it being important not to oil them! When you say to clean it out is it possible to remove the back of it? Or is it a case of taking the bevel off and removing the glass? Cheers. Bruce.
Yes, I did oil the cable. It was before I read the current thread on here about it being important not to oil them! When you say to clean it out is it possible to remove the back of it? Or is it a case of taking the bevel off and removing the glass? Cheers. Bruce.
- robcurrie
- Member
- Posts: 956
- Joined: Fri Dec 09, 2011 5:33 pm
- Location: Limpopo SOUTH AFRICA
- Contact:
Re: Stuck Chronometric Speedo
I'm not sure which model you have, mine has the screw on bezel, and the works comes out after removing screws in the bottom. Try not to disturb the painted numbers on the odo with the meths!
Rob C
Rob C
- thornebt
- Posts: 488
- Joined: Sun Apr 19, 2015 9:13 am
- Location: Somerset, UK
Re: Stuck Chronometric Speedo
I took the speedo out today. It certainly appears to have a screw on bezel as I can see a fine thread. I have tried unscrewing the bezel using rubber gloves to get a good grip on the body and the bezel but cannot shift it. It's probably been screwed on for sixty years!robcurrie wrote:I'm not sure which model you have, mine has the screw on bezel, and the works comes out after removing screws in the bottom. Try not to disturb the painted numbers on the odo with the meths!
Rob C
Does anyone have any ideas on how to shift it please? Maybe seal it in a plastic bag and put it in the freezer? WD40 on the thread? Cheers. Bruce.
-
- Member
- Posts: 8598
- Joined: Wed Sep 01, 2004 1:00 am
- Location: WEST SUSSEX UK
Re: Stuck Chronometric Speedo
Any good?
You do not have the required permissions to view the files attached to this post.
'There is a tide in the affairs of men
Which taken at the flood............'
Which taken at the flood............'
- thornebt
- Posts: 488
- Joined: Sun Apr 19, 2015 9:13 am
- Location: Somerset, UK
Re: Stuck Chronometric Speedo
Hi Neville. That looks really good. Presumable it's tried and tested by yourself? I thought the wood might slip on the bezel,but perhaps some innertube rubber might help if that's the case.
You obviously had the same problem as me? Cheers. Bruce.
You obviously had the same problem as me? Cheers. Bruce.
-
- Member
- Posts: 8598
- Joined: Wed Sep 01, 2004 1:00 am
- Location: WEST SUSSEX UK
Re: Stuck Chronometric Speedo
No, to be honest I've not tried it but it was posted here in the 'Photos' section by the venerable ITMA many years ago.thornebt wrote:Hi Neville. That looks really good. Presumable it's tried and tested by yourself? I thought the wood might slip on the bezel,but perhaps some innertube rubber might help if that's the case.
You obviously had the same problem as me? Cheers. Bruce.
'DCI' Clive has posted something similar in the past. He used to repair speedos until (I believe) the parts became virtually unobtainable and may have other suggestions but it's a common problem.
Just remembered that an oil filter removal strap is said to do the trick.
'There is a tide in the affairs of men
Which taken at the flood............'
Which taken at the flood............'