Hi Everyone
I'm rebuilding a 1929 M6 and am currently at the 'take everything apart and see what needs doing' phase.
I've never worked on girder forks before and am a bit cautious about any stored energy that may be in the spring when I release it.
Is this something to be concerned about If so, what is the technique for releasing the spring gradually
Cheers
Tim
Girder Forks dismantling
-
- Member
- Posts: 31
- Joined: Thu Mar 31, 2022 5:47 am
- Location: Nsw AUSTRALIA
- Rob Harknett
- Member
- Posts: 11236
- Joined: Mon Jan 01, 1990 12:00 am
- Location: ESSEX UK
Re: Girder Forks dismantling
It depends how you wish to use the bike. Tighten it for high speed. You may not want it solid as a rock. Loosen it off, you may not want it bouncing too much. do a few tests round bends to get it right.
-
- Member
- Posts: 8559
- Joined: Wed Sep 01, 2004 1:00 am
- Location: WEST SUSSEX UK
Re: Girder Forks dismantling
Welcome, Tim.
I know little about girder forks but there's this guide to renovation in Christians Archive which may be useful.
http://archives.jampot.dk/technical/Sus ... tion_1.pdf
I know little about girder forks but there's this guide to renovation in Christians Archive which may be useful.
http://archives.jampot.dk/technical/Sus ... tion_1.pdf
'There is a tide in the affairs of men
Which taken at the flood............'
Which taken at the flood............'