Hi, I'm new to the club and trying to get an old 1961 AJS 650 back on the road after 40 years.
I've had the Magneto serviced and repaired and about to put it back on.
The replacement gasket is green soft on one side and grey/black slightly rougher the other side.
Does it matter which way around it goes, and would it be advisable to use well seal on both sides as it goes back on ?
When I took it off the HT leads and advance / retard cable all went between the manifold and the cylinder head. Do you think this is the best routing or would at least the HT leads be better running outside directly to the plugs ?
Thanks John
K2F Magneto gasket replacement
-
- Member
- Posts: 30
- Joined: Tue Dec 29, 2020 10:13 pm
- Location: JERSEY
- dave16mct
- Member
- Posts: 3234
- Joined: Mon Jan 01, 1990 12:00 am
- Location: LANCASHIRE UK
Re: K2F Magneto gasket replacement
I've never heard of that gasket but I usually put Wellseal on one side and grease the other. I put the HT leads and A/R cable between the manifold and cylinder head.
Dave.
Dave.
-
- Member
- Posts: 30
- Joined: Tue Dec 29, 2020 10:13 pm
- Location: JERSEY
Re: K2F Magneto gasket replacement
Thanks Dave
In that case I think the slightly softer green side of the gasket must be for the magneto to sit on, (which I'm assuming you're meaning that's the side you would grease), and the gasket to engine casing is the grey/ black with well seal.
In that case I think the slightly softer green side of the gasket must be for the magneto to sit on, (which I'm assuming you're meaning that's the side you would grease), and the gasket to engine casing is the grey/ black with well seal.
- dave16mct
- Member
- Posts: 3234
- Joined: Mon Jan 01, 1990 12:00 am
- Location: LANCASHIRE UK
Re: K2F Magneto gasket replacement
I would 'stick' the gasket to the mag with wellseal. Then grease the timing cover. Then if you need to remove the mag, the gasket stays on it. Same with the rocker caps. Just makes it easier for checking the tappets.
Dave.
Dave.
-
- Member
- Posts: 30
- Joined: Tue Dec 29, 2020 10:13 pm
- Location: JERSEY
Re: K2F Magneto gasket replacement
Makes sense. Thanks again. Do you have a grease you'd recommend by any chance ?
- dave16mct
- Member
- Posts: 3234
- Joined: Mon Jan 01, 1990 12:00 am
- Location: LANCASHIRE UK
Re: K2F Magneto gasket replacement
Just any LM bearing grease.
Dave.
Dave.