Page 4 of 4

Re: Exhaust valve seat again G11CS

Posted: Mon Dec 08, 2014 5:13 pm
by JEAN-NOEL
Hi Clive,
I can recommend T & L Engineering, in Elstow (Bedford). They are helpfull, and their prices are friendly. I have dealed with Derrick. They advertise in Jampot Magazine.

Re: Exhaust valve seat again G11CS

Posted: Sat Dec 13, 2014 10:43 am
by clive
Thanks for all the advice guys, our local section engineering genius has rotated the valve seat, under heat, and then pinned it through with a 4 BA screw. This is the fix he did on the other head. So for the time being this will be it. Unfortunately 5 days after my off road incident I decided to get my leg x-rayed, and 5 and a half hours in the local A and E and I am leaving with my leg in plaster due to a broken fibula. That's no driving and as the garage is 1.5 miles away I think the rebuild is going to have to go on hold for a while. :cry:

Re: Exhaust valve seat again G11CS

Posted: Sat Dec 13, 2014 1:09 pm
by Rob Harknett
Hope the break soon heals without further problems Clive. I seem to recall you once turning up at a Jampot rally years ago, with a whole leg in plaster. Now just you take care.

Re: Exhaust valve seat again G11CS

Posted: Tue Feb 10, 2015 5:31 pm
by clive
Well the leg is mended and so I thought was the engine, but I had only gone about a mile and the gasket blew in that gap between the two barrels. Hey ho that means redoing the whole reassembly. It was a single gasket I had which I thought was ok but obviously not, or I didn't crank the head down properly. Good job I am retired.

Re: Exhaust valve seat again G11CS

Posted: Tue Feb 10, 2015 6:04 pm
by ajscomboman
Got so fed up blowing gaskets on the CSR that I changed to solid copper with O rings around the oil-ways, touch wood all ok so far.

Re: Exhaust valve seat again G11CS

Posted: Tue Feb 10, 2015 6:11 pm
by G15 Roy
ajscomboman wrote:Got so fed up blowing gaskets on the CSR that I changed to solid copper with O rings around the oil-ways, touch wood all ok so far.
But you must check them every 100 miles.

Re: Exhaust valve seat again G11CS

Posted: Tue Feb 10, 2015 6:59 pm
by ajscomboman
Don't exaggerate, every 101 miles. :P

Re: Exhaust valve seat again G11CS

Posted: Sat Feb 14, 2015 9:14 pm
by clive
Well that's the gasket replaced and cranked down as per instructions from Mr President. I imagine I will be making a warranty claim against him if the gasket goes again. ;)

Re: Exhaust valve seat again G11CS

Posted: Sun Feb 15, 2015 4:11 am
by robcurrie
No warranty, the only cover he offers is a layer of iron oxide and that doesn't apply to copper :rofl:

Rob C

Re: Exhaust valve seat again G11CS

Posted: Mon May 18, 2015 8:59 am
by clive
So no warranty claim about 750 miles covered and no gasket problems. Drivers of undertaking cars that spill you down the road however have no such guarantee of no legal action, especially when you have a witness. 👽