Hi Pharisee,
That helps greatly. Managed to get trouble spacer onto spindle correctly ( needed a bit of a de burr ) . The remaining , smaller shouldered spacer, goes on outside of frame/ brake side looking at your picture. Does the reduced shoulder butt against the frame? Even though it is a reduced diameter it will not pass through the fork slot.
Nearly there!
Thanks, Steve
Rear wheel hub assembly
- G3L1946
- Member
- Posts: 542
- Joined: Tue Feb 25, 2020 1:57 pm
- Location: North Yorkshire UK
Re: Rear wheel hub assembly
You do not have the required permissions to view the files attached to this post.
-
- Posts: 2886
- Joined: Mon Mar 24, 2014 5:44 pm
- Location: Aberdeenshire
Re: Rear wheel hub assembly
Hi
As Pharisee says, the reduced diameter is to accept the stop switch mounting plate:
Regards Mick
As Pharisee says, the reduced diameter is to accept the stop switch mounting plate:
Regards Mick
You do not have the required permissions to view the files attached to this post.
- G3L1946
- Member
- Posts: 542
- Joined: Tue Feb 25, 2020 1:57 pm
- Location: North Yorkshire UK
Re: Rear wheel hub assembly
Ah!
Thank you Mick. Bit thicker than usual today, but now got it! My brake light looks like an after market job and fits differently.
Thanks to everyone, can now crack on.
Regards,
Steve
Thank you Mick. Bit thicker than usual today, but now got it! My brake light looks like an after market job and fits differently.
Thanks to everyone, can now crack on.
Regards,
Steve
- ajscomboman
- Member
- Posts: 3969
- Joined: Mon Jan 01, 1990 12:00 am
- Location: HAMPSHIRE UK
Re: Rear wheel hub assembly
If you don't want to fit the rear switch in that position swap the ends around and face the recess outward. We no longer stock the plain earlier type spacer.
- G3L1946
- Member
- Posts: 542
- Joined: Tue Feb 25, 2020 1:57 pm
- Location: North Yorkshire UK
Re: Rear wheel hub assembly
Hi,
Thanks, will do.
Steve
Thanks, will do.
Steve