G2 CSR Steering bump stops!?!

Information relating to the Matchless G2 or AJS Model 14 250cc Lightweight
User avatar
Biscuit
Deceased
Posts: 3924
Joined: Thu Jan 01, 1998 12:00 am
Location: KENT UK

G2 CSR Steering bump stops!?!

Post by Biscuit »

The straight, centre portion is 5" long, that is between the beginning of the bends. The handlebars I bought from Armours struck the tank at full lock, replaced them from 'bars bought from JSL and the were fine.



itma
Posts: 7725
Joined: Tue Nov 22, 2005 6:01 pm
Location: UK

G2 CSR Steering bump stops!?!

Post by itma »

right, no point in putting a photo up.
the easiest way to fit a bump stop is to ustilise that hole on the down tube and use a couple of penny washers, the big ones you can get ought to provide enough clearance and you can work it out from there.
Its what I use on my rigid as the check springs foul the tank otherwise
basketcase
Posts: 141
Joined: Sat Jan 15, 2005 12:00 am
Location: STAFFORDSHIRE UK

G2 CSR Steering bump stops!?!

Post by basketcase »

The distance between the bends is 5", the same as yours itma. If I bolt washers as you say Ken then the yoke will probably miss them, they would have to be quite large penny ones. I`ll take photo and e-mail it to you to show you what I mean, if that`s possible.
basketcase
Posts: 141
Joined: Sat Jan 15, 2005 12:00 am
Location: STAFFORDSHIRE UK

G2 CSR Steering bump stops!?!

Post by basketcase »

The distance between the bends is 5", the same as yours itma. If I use bolt washers as you say Ken then the yoke will probably miss them, they would have to be quite large penny ones. I`ll take photo and e-mail it to you to show you what I mean, if that`s possible.
Post Reply