Hi all,
I'd be grateful if someone could measure the inner diameter (I.D.) of the 1-1/4" stanchions.
Regards,
Knut
Teledraulic stanchions
-
- Member
- Posts: 373
- Joined: Wed Feb 01, 2012 1:22 pm
- Location: Vestland NORWAY
- dave16mct
- Member
- Posts: 3234
- Joined: Mon Jan 01, 1990 12:00 am
- Location: LANCASHIRE UK
Re: Teledraulic stanchions
I just measured an old one I use for a lever. I make it 0.905" or 23mm at the bottom end. My vernier is not the best and the tube is a bit rusty so maybe not the most accurate.
Dave.
Dave.
-
- Member
- Posts: 373
- Joined: Wed Feb 01, 2012 1:22 pm
- Location: Vestland NORWAY
Re: Teledraulic stanchions
Much appreciated. Thanks, Dave. I assume the specification calls for 29/32" = 0.90625.
Regards,
Knut
Regards,
Knut